In most cases, the switch software brings down the sc0 interface after you confirm the change. Therefore, when you enter a command that causes sc0 and me1 to have the same IP address or occupy the same subnet, the switch software brings one of the interfaces down. The switch IP routing table is used to forward traffic originating on the switch only, not for forwarding traffic sent by devices that are connected to the switch.īecause sc0 and me1 are two distinct interfaces, they potentially can have duplicate IP addresses or overlapping subnets. For intersubnetwork communication to occur, you must configure at least one default gateway for the sc0 or me1 interface. When you configure the SLIP (sl0) interface, you can open a point-to-point connection to the switch through the console port from a workstation.Īll IP traffic that is generated by the switch (for example, a Telnet session that is opened from the switch to a host) is forwarded according to the entries in the switch IP routing table. When you configure the IP address, subnet mask, and broadcast address (and when you configure VLAN membership on the sc0 interface) of the sc0 or me1 interface, you can access the switch through Telnet or SNMP. The out-of-band management interfaces (me1 and sl0) are not connected to the switching fabric and do not participate in any of these functions. The in-band (sc0) management interface is connected to the switching fabric and participates in all of the functions of a normal switch port, such as spanning tree, Cisco Discovery Protocol (CDP), and VLAN membership. The Catalyst 4500 series, the Catalyst 2948G, Catalyst 2948G-GE-TX, and the Catalyst 2980G switches have three management interfaces: Renewing and Releasing a DHCP-Assigned IP Address Understanding How the Switch Management Interfaces Work.Using DHCP or RARP to Obtain an IP Address Configuration.Configuring the SLIP (sl0) Interface on the Console Port.Setting the Management Ethernet (me1) Interface IP Address.Setting the In-Band (sc0) Interface IP Address.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |